Modulation Effects; Room Effects - Concert CDP2400USB User Manual

8
4.2.1 Color equalizer
Use the Color equalizer to change the sound character and make it
softer or more brilliant.
1) Change the sound character with the COLOR control as
follows:
•
Move the control to the left (
darker in tone.
•
Move the control to the right (
sound.
4.2.2

Room effects

The CDP2400USB provides room effects simulating four reverb
rooms of different sizes. When you select a sound, the CDP2400USB
also selects an appropriate effect. If required, however, you
can always select any other effect. The following reverb room
simulations are available:
CHAMBER:
Simulates a small room.
CONCERT: Simulates a small concert hall.
CHURCH: Simulates a large concert hall.
THEATER:
Simulates a typical stage ambience.
1) Keep pressing the REVERB button until the effect of your
choice has been selected.
The active effect is shown by an LED lighting up next to the effect
name.
◊
If none of the four LEDs lights up, the room effect is
disabled.
2) Keep the REVERB button pressed while adjusting the original
vs. effect signal ratio in the VALUE/SONG section using the
-/ NO and +/YES buttons.
+
The display reads:
Effect intensity
0 . . . 20:
(0 = no effect, 20 = maximum effect)
) for a softer sound that is
) for a more brilliant
CONCERT CDP2400USB User Manual
3) If you want to restore the default settings, keep the REVERB
button pressed, then press -/NO and +/YES simultaneously.

Modulation effects

The CDP2400USB provides a modulation effect featuring four
different types of effect. When you select a sound, the CDP2400USB
automatically adds an appropriate effect for some of the sounds.
If required, however, you can always select any other effect. The
following modulation effects are available:
CHORUS: Chorus effect. "widens" the sound.
FLANGER: Time-shifted layering of sounds. Produces a
"floating" sound.
TREMOLO: Rapid, constantly repeated changes in the volume
of the sound.
DELAY:
Echo effect. Produces time-shifted repetitions of
the sound that decay over time.
1) Keep pressing the SPECIAL button until the effect of your
choice has been selected.
The selected effect is shown by an LED lighting up next to the
effect name.
◊
If none of the four LEDs lights up, the modulation effect is
disabled.
2) Keep the SPECIAL button pressed while adjusting the original
vs. effect signal ratio in the VALUE/SONG section using the
-/ NO and +/YES buttons.
+
The display reads:
Effect intensity
0 . . . 20:
(0 = no effect, 20 = maximum effect)
3) If you want to restore the default settings, keep the SPECIAL
button pressed, then press -/NO and +/YES simultaneously