Concert CDP2400USB User Manual page 14

14
◊
If you are not sure whether a track has been recorded or not,
check this by pressing the TRACK 1 and TRACK 2 button,
BEFORE you enter record mode. If one of the PLAY LEDs
above the TRACK buttons light up, this shows you that
something has been recorded on this track.
1) If you do not want to hear the previously recorded track while
you record the second one, press the TRACK button of the
track until its green PLAY LED goes out. Do this BEFORE you
enter record mode. If you want to hear the previously
recorded track, continue with step #2.
2) Press the REC button. The REC LED above the TRACK 1 or
TRACK 2 button lights up. The dots on the display start
flashing in the metronome tempo that has been set, thus
indicating the beat. Now, the CDP2400USB is set to record
mode.
◊
The memory of the music sequencer can store up to 10,000
notes. However, this number can decrease depending on
how much pedaling information is stored.
◊
You can quit record mode by pressing the REC button again.
3) Press the TRACK button of the track you want to record until
the REC LED above the button lights up red. Now the selected
track is record-ready. If you did a recording take before, the last
track selected will be used for recording. Depending on which
track is currently used, you will have to select the other track
for recording.
CONCERT CDP2400USB User Manual
◊
Tip: If you select a track for recording, which already
contains note information, all previously recorded notes on
this track will be erased!
4) Select a sound in the TONE section. You can also use a sound
combination (see chapter 4.1) for recording.
5) Switch on the acoustic metronome signal by pressing the
CLICK button, if you want to make a metronome-backed
recording.
6) Start recording by pressing the
playing on the keyboard. The current meter is constantly
shown in the display.
◊
If the display starts flashing during recording and reads the
message FUL, this is to warn you that the recording memory
has been used up. All data recorded up to this point will be
stored, however, but recording process will be terminated.
7) Once your recording is finished stop the sequencer by
pressing the button again.
◊
Recording mode will thus be canceled automatically.
button or simply start