Programming; To Move The Driving Position To Programmed Position - Mazda CX-5 2017 Manual

Essential Safety Equipment
Seats
If the vehicle has been serviced and the
•
battery cables disconnected, the
programmed seat positions will have
been erased. Re-program the seat
positions.

Programming

1. Make sure the parking brake is on.
2. (Automatic transaxle)
Make sure the selector lever is in the P
position.
3. Start the engine.
4. Adjust the seat and the active driving
display to the desired driving position.
5. Press the SET button on the seat until a
beep sound is heard one time.
6. Perform one of the following settings
within 5 seconds of completing step 5
above:
Programming using a button on
•
the side of the seat
Press the button you want to
program, either button 1 or 2, until a
beep sound is heard one time.
Programming using the key
•
Press the key button until a beep
sound is heard one time.
NOTE
If a beep sound is heard three times, the
operation is canceled.
To move the driving position to a
programmed position
(Using a button on the side of the seat)
1. Make sure the parking brake is on.
2. (Automatic transaxle)
Make sure the selector lever is in the P
position.
3. Start the engine.
2-8
CX-5_8GB6-EA-17G_Edition1
4. Press the programming button for the
driving position you want to call up
(button 1 or 2).
5. A beep sound is heard when the
driving position adjustment is
completed.
NOTE
If the driving position movement is not
•
changed, only the beep sounds.
A seat position can be called up even
•
with the engine not running.
The driving position adjustment is
•
canceled in the following cases:
Any of the seat adjustment switches is
•
operated.
The SET button is pressed.
•
Programming button 1 or 2 is pressed.
•
The key button or
•
operated.
The vehicle starts moving.
•
The active driving display is adjusted.
•
(Using a programmed key)
1. Unlock the doors by pressing a request
switch or the key
2. After unlocking the doors, the seat
position adjustment begins within 40
seconds of opening the driver's door,
and a beep sounds when the operation
is finished.
3. Make sure the parking brake is on.
4. (Automatic transaxle)
Make sure the selector lever is in the P
position.
5. Start the engine.
6. The active driving display adjustment
begins.
button is
button.
2017-5-18 10:43:27