Table of Contents
Advertisement
7 Then put the drawer module back in
place and line up the holes.
8 Use a hammer to start to insert the
screws into the floor.
9 Tighten the two screws into the floor to
secure the drawer module firmly.
10 Now refit the drawers. To do this, pull
the slides on both sides fully out,
including the inner ball-bearing slide.
11 Then fit the drawer slides inside the
drawer module slides.
12 When the slides are inserted, push the
drawer in fully. It may be a bit hard the
first time. Perform this operation to fit the
four drawers.
13 Finally, having fitted the top surface,
raise the screws on top at the back until
they meet the top surface. If the screws
fitted are not long enough, change them
for the two longer ones supplied in a bag.
Wall
M6x30 or M6x50
Hexagonal screw
Top surface
Drawer module
20
Advertisement
Table of Contents
