Table of Contents
Advertisement
4.5. Instructions for the installer
4.5.1 Assembly Instructions.
1 WARNING! Be careful when opening the
drawers before the drawer module is secured
to
the
floor.
THE
OVERTURN.
2 Remove the drawers by opening them fully,
lifting the two tabs on the slides and pulling
the drawer horizontally until released. Perform
this operation until all 4 drawers are removed.
3 Fit the drawer module in position and raise
it to the required level by turning the legs
with a wrench.
MODULE
MAY
4 Fit the brackets with which you are going
to secure the module to the floor. Screw
them onto the module with a grover washer
and a normal M6 washer. Do this on both
sides.
5 Mark the two holes indicated by the
brackets.
6 Remove the drawer module from
position and drill the holes in the floor
with an 8-mm bit.
19
Advertisement
Table of Contents
