Kipor KDE180XW Operator's Manual page 8

3.2.2 Filling the Machinery Oil
Lubrication Oil Filling Inlet
Put the generator set in a level state. Fill the oil into the oil-filling inlet. At the time
of checking the oil level, it is necessary only to lightly insert the oil ruler. Please
pay attention to that you should not rotate the oil ruler.
Top Limit
Lower Limit
Type
KM186FG
Volume
Volume (L) English gallon 1.65 (0.36)
The factor of the affection, to the performance and reliability of the diesel engine,
caused by your lubrication oil, is bigger than other factors. If you use any poor
quality machinery oil or if you do not change the oil for your diesel engine
according to stipulation, it is easy to block up the piston. It is also to quicken the
wearing of the cylinder, bearings, and other moving components so that the life of
your diesel engine is reduced.
About one month or 20 hours Interval of 3 months or 100 hours
Time for changing the oil
- -
Operating temperature
Recommended value
Applicable limit
A.P.I. Diesel engine maintenance
classification. The lubrication oil
should be CC or CD grade.
Although there are the low oil pressure alarm system---the stop device. At
the time of starting the set, it is necessary to check the oil quantity. If the oil
quantity is not sufficient, please add some oil. Discharging the machinery
oil should be carried out while the diesel engine is hot. After the cooling, it
is very difficult to discharge the oil cleanly.
Oil Drain Bolt
Don't fill the machinery oil into the diesel engine
WARNING
when the diesel engine id running.
3.2.3 Check the air filter.
(1) Unfasten the butterfly nut, open the filter cover, and take out the filter
core. Never wash the filter core by using any detergents. When the output
is reduced or the color of the exhausted gas is not good, change the filter
core. Never start the generator set without the air filter core. Otherwise the
diesel engine will soon be worn out.
Filtration Cover
Cover of Air-filter
(2) After mounting the filter core, cover the air filter housing and fasten the
butterfly nut.
- -
Oil-filling Hole Cock
(Dipstick)
Check Cover of Air-filter
Butterfly Screw