Starting The Welder And Generator Set - Kipor KDE180XW Operator's Manual

(1) Avoid the overload.
During the trial run stage, it is necessary to avoid the large load. It uses only
75%of the rated load.
(2) Change the machinery oil of the engine according to the stipulation.
At the beginning of the use, change the oil once each 20-hours or once a month.
After this, change the oil once each 3-months or once for each 100-hours.

3.4 Starting the Welder and Generator Set

3.4.1. Recoil start (manual start)
Start the engine according to the following
procedures:
(1) Switch on the fuel oil switch (in ON
position).
(2) Set the speed handle of the engine at
run position.
(3) Draw out the buffer start handle.
a. Draw out the handle till you feel your hand
has the resistance force. Then relieve it and
let it restore to the initial position.
b. Press down the pressure reduction handle
(when the buffer starter is drawn, it will
automatically be restored.).
- -
Fuel Switch
Speed Handle
Decompression Lever
c. Quickly draw out the buffer start handle by two hands.
While operating (or after the start), don't let the handle fly out of your hand to
avoid that it smashes onto the diesel engine. Slowly and lightly let the handle
return its position to avoid damaging the starter.
When the diesel engine is running, never draw out the
CAUTION
start handle otherwise it will damage the diesel
engine.
d. In the cold days, when it is difficult to start the
diesel engine, unplug the rubber cock on the
rocker arm of the diesel engine and fill in 2ml
machinery oil.
Plug the rubber cock before the start.
The rubber cock should be plugged except filling
in the oil. Otherwise the rain, water, dust and
other dirt may enter into the diesel engine to
cause the fast wearing of the inside components.
This will result in serious problem.
3.4.2 Electric start
3.4.2.1 Start (the preparation for this start is the
same as the hand start.)
(1) Insert the electric door key and make it in
OFF position.
(2) Set the speed handle of the diesel engine in
run position.
(3)Turn the start switch to start position
clockwise.
(4) After the diesel engine starts, your hand should relieve the switch handle. Let
the switch restore to ON position automatically.
(5)If the diesel engine doesn't start after 10 seconds, please wait for anther 15
seconds and make the start again.If the start motor rotates for a long time and the
voltage of the battery will go down to cause the start motor running hysteresis.
When the diesel engine is in operation always leave the start key in ON position.
- -
Speed Hande