Preparation Before The Start - Kipor KDE180XW Operator's Manual

In order to prevent the electric shock, the welder and generator set should be
grounded. Connect the grounding terminal of the generator with the external
grounding device by using a conductor. Please see Fig.2-1 and Fig.2-2. Before
the start, don't connect the other equipment with the welder and generator set.
Potentiometer
Electric Lock
Wiring Terminal
AC Output Receptacle
NOTE At the time of the start, most motors will exceed their
rated power. On any sockets, the current should not
exceed the stipulated limit.
3.1.5 Other safety main points
In order to know how to quickly brake the set, the operators should be familiar
with operating all the switches. Anyone without passing through the correct
guidance should not carry out the operation. The operators should wear the
safety shoes and the suitable clothes. The children and livestock should be kept
far from the welder and generator set.
3.1.6 Charge the battery.
The electrolyte of the battery contains sulphuric acid. In order to protect your eyes,
skin and clothes, if you touch it, it is necessary to use water for wash. If your eyes
touch it, you should go to a clinic for wash.
The hydrogen produced from the battery is the explosive gas. Don't smoke
particularly at the charge time. Any spark should not be splashed to the places
near the battery.
Charge the battery at the places with good ventilation.
-8-
Fuse
Automatic Air Switch
Grounding Terminal

3.2 Preparation before the Start

3.2.1 Select and treat with combustion oil.
Combustion oil tank
Only use the light diesel oil. The combustion oil should filtered
cleanly. The attention should be paid to that don't let any dust and
water to be mixed into the combustion oil and the oil tank. Otherwise
the high-pressure pump and the oil nozzle may be blocked up.
Attention: Overflowing the oil is very dangerous. Filling the oil into
the oil tank should not exceed the top of the red cock inside the filter.
Air filter core
Don't wash the air filter core because the component is
the dry type. When the diesel engine output is not good
or the color of the exhausted waste gas is abnormal,
change the filter core immediately. Never start the
diesel engine without using the filter core.
a. After purchasing the fuel, put the fuel in the
barrel for 3 to 4 days.
b. After 3 to 4 days, put the suction pipe into
the barrel at the place with a half depth of the
barrel (water and foreign matter will be sunk
onto the lower position in the barrel.)
At the places of filling the oil into the diesel engine or
NOTE
of storing the diesel oil, don't smoke. Don't let any
spark go into this area. At the time of filling the oil, the
oil should not be overflowed. After the oil filling, be
sure fastening the cover nut on the oil inlet.
-9-
Cap
Red cock
Speed change lever
Stop
Start/Run
a b