Step 6, Connect Electrical - Monogram ZV830 Installation Instructions Manual

6 CONNECT ELECTRICAL
Verify that power is turned off at the source.
WARNING:
and aluminum-to-copper connectors.
a strain relief.
•
•
• Secure all the connections with wire nuts on each
electrical connector.
the cover. Be sure the wires are not pinched.
• Secure the
screws.
Installation Instructions
the 6
7 INSTALL DUCT COVERS
• Place the decorative duct
covers on top of the hood.
NOTE: The inside piece has vent
holes on one end intended for
use when the hood is installed
the vented end is at the top; the
installation.
The inside duct piece must slip
into the folded ends on the outer section.
duct cover
duct cover
cover seat
Screw holes
• Press up on the front corners of the filter cover panel
cover to the hood.
screws
Vent holes
Duct cover
Duct attachment