dot2 Software Update
All dot2 consoles can be updated to the latest software version with a free update.
The update can be found on our website www.malighting.com With this one can update all units of
the dot2 family, consoles and nodes to be updated - the dot2 F wing and the wing dot2 B need no
update.
Way to update your console via SETUP
Open the MA Homepage and select the software for the dot2 family in the "dot2" – area.
Download the dot2*.update file.
Copy the content into the root directory via a USB stick. Make sure there is only one file in the
root directory.
Insert the USB stick with the new software into one of the USB ports on the back.
Start CONSOLE, press SETUP and tap SOFTWARE UPDATE in the column CONSOLE.
The menu SOFTWARW UPDATE VIA USB opens.
Press button UPDATE.
Select whether the current show should be saved or not - CANCEL will abort the whole process,
then will be stored or start the update.
Wait a few seconds until the update is complete.
Start with REBOOT NOW the new console, so the update is complete.
Way to update your console via LINUX USB-stick
Das dot2*imgz – file und den MA STICKMAKER downloaden.
Install MA STICKMAKER on your PC – follow the installation guide.
Insert an empty USB-stick into your PC and double-click the desctop icon to start MA
STICKMAKER.
Select USB-stick, click on the three dots, select dot2*imgz and click on START.
Insert the now formatted USB-stick, connect an external monitor and an keyboard to your console
Press the Power-Button on the back of the console and press F10 on the keyboard several times
until the password request appears on the external monitor.
Press ENTER, select your USB-stick and press ENTER.
An POP-UP opens, select FACTORY RESET– after that the console resets and start rebooting.
Agree to LICENSE AGREEMENT to compete the Reset, The console is...ready to be used.
dot2
Data
Transport
Safety
Instructions
Limitation
Quickstart
Connect
Quickstart
ON / OFF
Maintenance
Conformity
57