Cleaning; Adjustments; Maintenance - Cecilware HWD2 Operator's Manual

Installation (continued)
NOTE: This procedure is for initial start - up only;
however, steps 4 and 5 must be repeated should the
tank be completely drained. Steps 1 thru 7 must be
repeated should the machine be drained, disconnected,
and reinstalled in a new location.
CAUTION: BURN HAZARD
Water from unit is very hot. Use caution when
pouring or transporting hot water. Accidental spills
may result in severe burns.

Cleaning

CAUTION: BURN HAZARD
Dispenser surfaces and water inside dispenser are very
hot. Use caution when cleaning unit to prevent burns.
CAUTION: BURN HAZARD
Never remove faucet when the liner has water in it.
Switch OFF the power to the unit at the circuit
breaker. Turn off the water line running to the boiler.
NOTICE:
All sanitizing agents in the food zone must
comply with 21 CFR 178.1010. Sanitize all food
dispensing units periodically. All parts to be sanitized
must be cleaned first. Cleaning and sanitizing frequency
must follow state and local health department
regulations.
NOTICE:
Do not use cleansers, bleach liquids, powders
or any other substance containing chlorine. These
products promote corrosion and will pit the stainless
steel. USE OF THESE PRODUCTS WILL VOID THE
WARRANTY.
Daily
Wipe the outside of the unit with a damp cloth, using
soap solution or a non-abrasive compound when
required.
Sanitizing
1. Disconnect power to the unit.
2. Drain all water from the unit slowly.
3. Disassemble faucet
dishwashing liquid and rinse.
4. Prepare a sanitizing solution in accordance with
local health department regulations. You may also
refer to the US Food and Drug Administration
regulation 21 CFR 178.1010 "Sanitizing Solutions"
and US Environmental Protection Agency 40 CFR
18.940 "Tolerance exemptions for active and inert
ingredients for use in antimicrobial formulations
(Food-contact surface sanitizing solutions)".
5. Follow the instructions provided with the sanitizing
agent.
6. Let all sanitized parts drain and dry naturally. DO
NOT WIPE THEM DRY.
Hot Water Dispensers
and shank. Clean with
Cecilware

Adjustments

Thermostat Adjustment
1. Thermostat can be adjusted by pushing up or down
on the front control below the temperature display.
2. Hold down both up and down at the same time to
switch between Fahrenheit and Celsius.
3. Unit should be set to approximately 200°F.

Maintenance

WARNING: SHOCK AND BURN HAZARD
To prevent electric shock and burn hazard, this
procedure must be performed by a trained and
qualified service technician.
WARNING: SHOCK HAZARD
Disconnect power before attempting any electrical
repairs.
The rest of this manual contains information to aid the
service technician who is maintaining this equipment.
This section has information on performing common
service tasks.
If you still need help after reading this section, call
Grindmaster-Cecilware Technical Service Department,
(502) 425-4776 or (800) 695-4500 (USA & Canada only)
(Monday through Friday 8 AM - 6 PM EST). Please have
the model and serial number ready so that accurate
information can be given.
Prior authorization must
Grindmaster-Cecilware for all warranty claims.
Grindmaster-Cecilware provides the industry's
BEST warranty. Visit our website at gmcw.com for
warranty terms and conditions.
®
be obtained from
5