Specifications; Installation - Cecilware HWD2 Operator's Manual

Specifications
Model Certifications
NSF Sanitation;
HWD2
cULus Electrical
NSF Sanitation;
HWD2
cULus Electrical
NSF Sanitation;
HWD3
cULus Electrical
NSF Sanitation;
HWD3
cULus Electrical
NSF Sanitation;
HWD5
cULus Electrical
NSF Sanitation;
HWD5
cULus Electrical
Side Clearance required - 4" (10.2 cm)
Rear Clearance required - 4" (10.2 cm) for water and electrical connections
Water connection size - 3/4" GHT (garden hose thread)
Water pressure between 20 PSI and 120 PSI (138 kPa - 827 kPa). Use regulator if higher pressure.

Installation

WARNING: ELECTRIC SHOCK HAZARD!
Installation of this appliance should be performed by
qualified service personnel only. Improper installation
could result in electrocution.
Unpacking Instructions
Carefully unpack the machine and inspect immediately
for shipping damage. The packaging may contain
unattached parts. Your machine was shipped in a carton
designed to give it maximum protection in normal
handling. It was thoroughly inspected before leaving
the factory. In case of damage, contact the shipper, not
Grindmaster-Cecilware.
See Rough-in Drawing for approximate dimensions
and locations of electric and water input.
NOTICE:
This equipment must be installed in
compliance with applicable Federal, State, and/or Local
plumbing codes having jurisdiction. This product requires
an approved back flow prevention water device, such as
a double check valve, to be installed between the
appliance and the water supply. If a check valve type
backflow preventer is used for water supply protection,
a screen of at least 100 mesh (100 strands per 1.0 in [25
mm]) shall be installed immediately upstream. The screen
shall be accessible and removable for cleaning or
replacement. (Required for NSF approved water hook-
up.)
Incoming pressure should be greater than 20 psi and not
more than 90 psi.
•
Connecting the unit to a warm water supply will
4
Water Tank Electrical
2 gal 115V / 1Ph / 50/60 Hz / 11.5 A / 1300 W
7.6 L 120V / 1Ph / 50/60 Hz / 14 A / 1700 W
2 gal 208V / 1Ph / 50/60 Hz / 11 A / 2300 W
7.6 L 240V / 1Ph / 50/60 Hz / 13.5 A / 3000 W
3 gal 115V / 1Ph / 50/60 Hz / 11.5 A / 1300 W
11.3 L 120V / 1Ph / 50/60 Hz / 14 A / 1700 W
3 gal 208V / 1Ph / 50/60 Hz / 11 A / 2300 W
11.3 L 240V / 1Ph / 50/60 Hz / 13.5 A / 3000 W
5 gal 115V / 1Ph / 50/60 Hz / 11.5 A / 1300 W
19 L 120V / 1Ph / 50/60 Hz / 14 A / 1700 W
5 gal 208V / 1Ph / 50/60 Hz / 11 A / 2300 W
19 L 240V / 1Ph / 50/60 Hz / 13.5 A / 3000 W
Cecilware
24" x 9.4" x 21.25"
61 cm x 24 cm x 54 cm
24" x 9.4" x 21.25"
61 cm x 24 cm x 54 cm
24" x 9.4" x 21.25"
61 cm x 24 cm x 54 cm
24" x 9.4" x 21.25"
61 cm x 24 cm x 54 cm
30" x 9.4" x 21.25"
76.2 cm x 24 cm x 54 cm
30" x 9.4" x 21.25"
76.2 cm x 24 cm x 54 cm
speed up heating and recovery times.
• A filtering system is recommended to remove odors
and inhibit lime and scale build up in the unit.
• In areas with extremely hard water, a water softener
must be installed in order to prevent a malfunctioning
of the equipment and in order not to void the warranty.
NOTICE:
Do not use extension cords. Make sure that the
outlet the unit plugs into is grounded. Check rating
marking on nameplate to be sure electric lines match
voltage, phase, and amperage requirements of
appliance.
Start-up Instructions
1. Connect waterline to the water supply connection.
2. Open the water shut-off valve and check
connections for leaks. DO NOT over-tighten.
3. Plug in the Hot Water Dispenser into a dedicated
power supply outlet.
4. Activate the Power Switch (front of unit) the water
tank will begin to fill, providing the water
connection is open. The tank will fill in
approximately 3-4 minutes.
5. After the tank has filled, the Heater will activate.
Depending on the model selected, it will take
approximately 15-25 minutes for the water to heat
to operating temperature.
6. Heat and discard at least one batch of water.
7. In high altitude locations (over 5000 ft. above sea
level), thermostat may have to be lowered to
prevent boiling. See the Adjustments section if
changes are needed.
®
Product Dimensions
(H x W x D)*
Hot Water Dispensers