11.14 Platform Control Buttons - ATX DigiVu Installation & Operation Manual

NOTE: This only works in MPTS mode.

11.14 Platform Control Buttons

11.14.1 Refresh Button
This control reads the stored settings and refreshes the page with the values. This
also will read the card types installed and populate the display with the discovered
types. This is useful when a card type has been changed or a new card is installed. This is not a service affecting operation.
11.14.2 Submit Button
NOTE: This is a service affecting operation.
This control applies all of the changes made on the 'IP Output' tab and makes the changes part of the working configuration of
the DigiVu system. If changes have been made click Submit button before navigating away from the page, to avoid all changes
being lost. This attribute may be used to throw away changes made if you change your mind.
DigiVu Series Multichannel MPEG-2/H.264 Encoder/Multiplexer with QAM &/or IP Output - Installation & Operation Manual
®
CHAPTER 11: IP OUTPUT TAB
Figure 11-14: Platform IP Control
Buttons
11-9