11. Ip Output Tab; Chapter Contents - ATX DigiVu Installation & Operation Manual

IP OUTPUT TAB

11. IP Output Tab

This chapter is about the configuration of the Gigabit Ethernet (GbE) card shown in Figure 11-1. The GbE option supports
transmission by multicast or unicast of the multiplex created by the encoders. The DigiVu platform can simultaneously create
a QAM and IP output with programming duplicated on both. In this case the IP output will be a single multiplex of the created
programs, an MPTS. If the DigiVu is configured for IP output only, then SPTS multiplexes may be created for each program.
In IP output only mode the user can select either SPTS or MPTS transmission, but not a mixture of both. See
Settings" on page 11-8
FYI: Activation of the 'IP Output' tab requires that an IP Card be installed. If there is one installed
check in the
Output' tab must also be activated on the 'Mux' tab. See
FYI: In this guide, reference to DigiVu infers DigiVu 3RU, DigiVu CD 3RU and DigiVu Mini 1RU
unless the model is specifically stated. Reference to DVIS is synonymous with DigiVu as these
products run on the same firmware.
11.1

Chapter Contents

• "Enabling the IP Output Tab"
• "Support for VLAN Tagging"
• "Gigabit Ethernet Card Fundamentals"
• "Quick Guide to the Gigabit Ethernet Card"
• "IP Output Configuration"
• "VLANS Settings"
• "GbE Port Numbering"
• "Two VLANs Automatically Created"
• "Stream Settings"
DigiVu Series Multichannel MPEG-2/H.264 Encoder/Multiplexer with QAM &/or IP Output - Installation & Operation Manual
®
to activate the SPTS feature.
"Encoder Settings Tab" on page 6-1
Figure 11-1: GbE Output Module
to see that the IP Card is detected. The 'IP
"Mux Tab" on page 7-1.
CHAPTER 11: IP OUTPUT TAB
"11.13 Stream
11-1