Du Pont WFQT13000 Series Installation Instruction Manual page 7

STEP 5
Install 1/4" Plastic Tubing for Water Supply Line from
Kitchen Faucet dapter to System Head Inlet
1
Determine the length of 1/4" Plastic Tubing
H
dapter . Make sure to allow enough Plastic Tubing to prevent kinking in the line.
2
Cut the 1/4" Plastic Tubing squarely on both ends.
3
Wet one end of the 1/4" Plastic Tubing with water and push it into the Kitchen Faucet dapter approximately 5/8" until it stops.
NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting.
4
Wet the other end of the 1/4" Plastic Tubing with water and push it into the System Head Inlet approximately 5/8" until it stops.
NOTE: The 1/4" Plastic Tubing does not need to be disconnected for general routine maintenance and filter replacement. However,
Plastic Tubing may be easily disconnected if necessary. Simply turn off the water supply to the Filter System and press in the grey collar
around the fitting while pulling the Plastic Tubing out with the other hand.
STEP 6
Install 1/4" Plastic Tubing for Water Supply Line from
System Head Outlet to Faucet
1
Determine the length of 1/4" Plastic Tubing
Stem. Make sure to allow enough Plastic Tubing to prevent kinking in the line.
2
Cut the 1/4" Plastic Tubing squarely on both ends.
3
Wet one end of the 1/4" Plastic Tubing with water and push it into the System Head Outlet until it stops.
4
Gently slide the plastic Compression Nut down
that the Ferrule is in the proper position with the larger opening on the bottom (going into the nut). Place the plastic Insert
the end of the 1/4" Plastic Tubing.
5 Firmly push the 1/4" Plastic Tubing into the end of the threaded Faucet Stem. Hand-tighten the plastic Compression Nut onto the
threads. Tighten with an adjustable wrench approximately 1/2 turn.
NOTE: Do not bend or crimp 1/4" Plastic Tubing when inserting. Do not over tighten the Compression Nut.
WFQT13000 & WFQT13500 Series
L
that will be necessary to connect the System Head Inlet to the Kitchen Faucet
L
that will be necessary to connect the System Head Outlet to the threaded Faucet
G
(thread side up) over the tubing. Follow with the plastic Ferrule
J
, making sure
I
into
7
5
HOT W TER COLD W TER
V LVE V LVE
1/4" PL STIC TUBING
INLET
4
6
INLET OUTLET
3
F UCET FOR
FILTERED W TER
I
J
G
4
5/8"
3
OUTLET
1/4" PL STIC TUBING
5
V4.0