Vcr1, 2 And V-Aux; Lv (Laser Video); Sat; Tape 1 And Tape 2 - McIntosh MX130 Owner's Manual

A/v tuner control center
Table of Contents

Advertisement

are connected. When an external signal processor is properly connected, the program signals
will feed to the processor from the MX130 PROCESSOR TO jacks, and return to the MX130
at the PROCESSOR FROM jacks.
Connect a pair of cables from the external processor Outputs to the MX 130 PROCESSOR
FROM jacks. Connect another pair of cables from the external processor Inputs to the MX130
PROCESSOR TO jacks.
WHEN AN EXTERNAL SIGNAL PROCESSOR IS CONNECTED TO THE MX130 RECORD
PROCESSOR JACKS, THE PROCESSOR MUST BE TURNED ON AND OPERATING, OR
IN BYPASS MODE, FOR THE PROGRAM SIGNALS TO BE FED TO THE VCR, TAPE OR
AREA "B" AUDIO OUTPUTS.
8. VCR1, 2 and V-AUX (Auxiliary)
Connect cables from the Audio Outputs of VCR units or other similar A/V Tuner accessories
to these three AUDIO INPUTS.

9. LV (Laser Video)

Connect a pair of cables from a Laser Video Disc player Audio Outputs to the LV AUDIO
INPUTS.
10. TV
Connect a pair of cables from the Audio Outputs of a TV set. TV Monitor or TV Tuner to
the TV INPUTS.
11. SAT (SATellite)
Connect a pair of cables from the Audio Outputs of a Satellite TV Tuner or Receiver to the
SAT INPUTS.

12. TAPE 1 and TAPE 2

Connect a pair of cables from the Outputs of two audio tape recorders to the TAPE 1 and
TAPE 2 INPUTS.
13. CD1, CD2
Connect a pair of cables from the output of two CD players to the CD1 and CD2 INPUTS.
For example, CD1 Inputs could be used for a single disc player, and CD2 Inputs for a CD
changer.
When the C39 is used with the CR10 Remote Control System, only the CD2 input will func-
tion with the CR10.
14. 75 Ohm FM ANTenna
Coaxial "F" type connector for a 75 ohm FM antenna. Four different types of FM antennas
can be used with the MX130.
1. The flexible 75 ohm indoor dipole antenna supplied with your MX130 makes a convenient
antenna for urban or high signal strength areas. Extend the two dipole sections as straight
as possible. The antenna can be tacked behind the enclosure cabinet, placed under a rug
or along the wall. Since the antenna is directional, you may have to experiment with the cor-
rect position for best reception of your favorite FM stations. An indoor antenna may not prove
effective in houses or buildings with metal siding or insulation.
2. An all channel (UHF-VHF-FM) antenna can be connected. This type of antenna will be
similar to the flexible dipole in reception, but may be more convenient to install.
THE
REAR PANEL
AND HOW
TO MAKE
CONNECTIONS
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents