McIntosh MX130 Owner's Manual page 18

The descriptions and (unctions of the MX 130 Remote Controller pushbuttons refer to the
MX130
numbers on the drawing.
HAND HELD
1. Select any of the 12 Audio or Audio/Video LISTEN program signals in Area "A". Select any
REMOTE
of the same 12 Audio or Audio/Video program signals in Area "B". The selected Area "B"
CONTROLLER
signals are also the RECORD program signals.
2. Select Tuner station presets or relay operation on the HC-1 Home Controller.
To operate the HC-1, first press the HOME pushbutton (4) and then the desired pushbut-
tons 0 through 9 (2) within five seconds to activate the relays on the HC-1.
To operate the Tuner presets, first press TUNER and then press any numbered pushbutton
1 through 8.
The number pushbuttons also function with the RCT-1 Remote Control Translator, when it
is programmed to allow the MX130 to remotely control other brand products.
3. Select CD Player, CD Changer or tape recorder functions.
Using a Mclntosh SINGLE DISC CD PLAYER, STOP. BACK TRACK, (
(
Using a Mclntosh CD CHANGER, STOP, BACK TRACK (
PLAY functions can be performed while a disc is playing.
When the CD c h a n g e r is in the STOP position, BACK TRACK (
DISC and NEXT TRACK (
pressing STOP, the first time you press NEXT (
as desired to select discs 2 through 6.
FOR EXAMPLE: To select disc number 6 from the single disc play mode, press STOP and
then NEXT (
twice. To select the disc in the SINGLE disc slot, press STOP and then press BACK (
4. Press HOME to operate the HC-1 Home Controller functions. Within five seconds press
a pushbutton number from 0 to 9 to control the desired relays on the HC-1.
5. Press SYS OFF to turn the entire MX130 system off from either Area "A" or Area "B".
In Area "B", pressing POWER turns on only Area "B" after the SYS OFF is activated.
6. Press POWER to turn on the main system in Area "A". Press in Area "B" to turn on just
Area "B" Outputs and dedicated power amplifier. Each time Area "B" is turned on, TUNER
is automatically selected at a volume level 50dB below maximum. The Area "A" power amplifier
and dedicated Area "B" power amplifier AC power cords must be connected to or controlled
by their respective MX130 rear panel Area "A" and Area "B" AC outlets.
7. Select Tuner functions of AM, FM, SEEK UP ( ) or SEEK DOWN ( ). When an RCT-1
Translator is being used to control a TV set, the SEEK UP or DOWN pushbuttons can be used
to change TV channels.
8. First press TUNER and then press REVIEW to start the automatic 3 second audition of
each of the preset stations stored in tuner memory. Press REVIEW again to stop on the desired
preset. Cancel the REVIEW process by pressing REVIEW a second time, or pressing any other
Tuner function pushbutton.
9. E, (ENTER or EXTRA) is used for controlling functions of an accessory component when
an RCT-1 Remote Control Translator is being used.
16
) and PLAY functions can be performed.
) six times. To select disc number 2, press STOP and then press NEXT (
} selects which of the other six discs you wish to play. After
), disc number 1 is selected. Press again
), NEXT TRACK
), NEXT TRACK ( } and
) selects the SINGLE
) once.
)