Important Instructions - Dimplex PF2325 Owner's Manual

IMPORTANT INSTRUCTIONS

When using electrical appliances,
basic precautions should always be
followed to reduce the risk of fire,
electric shock, and injury to persons,
including the following:
① Read all instructions before using
this appliance.
② The heater is hot when in use.
To avoid burns, do not let bare skin
touch hot surfaces. The trim around
the heater outlet becomes hot during
heater operation.
③ Extreme caution is necessary
when any heater is used by or near
children or invalids and whenever the
unit is left operating and unattended.
④ Always unplug the fireplace when
not in use.
⑤ Do not operate any heater after it
malfunctions. Disconnect power at
the service panel and have the unit
inspected by a reputable electrician
before reusing.
⑥ Do not operate any unit with a
damaged cord or plug, or if the heater
has malfunctioned, or if the electric
ireplace has been dropped or dam-
aged in any manner,
Technical Service at 1-888-346-7539.
⑦ Do not use outdoors.
⑧ Do not run the cord under carpet-
ing. Do not cover cord with throw
rugs, runners or the like. Arrange
4
contact Dimplex
cord away from trafic area and where
it will not be tripped over.
⑨ To disconnect the unit, turn the
controls off, then remove the plug
from the outlet.
⑩ Do not insert or allow foreign
objects to enter any ventilation or
exhaust opening as this may cause
an electric shock or ire, or damage to
the heater.
⑪ To prevent a possible ire, do not
block air intake or exhaust in any
manner.
⑫ All electrical heaters have hot and
arcing or sparking parts inside. Do
not use in areas where gasoline,
paint, or lammable liquids are used
or stored.
⑬ Do not modify the ireplace. Use it
only as described in this manual. Any
other use not recommended by the
manufacturer may cause ire, electric
shock or injury to persons.
⑭
To reduce the risk of electric
shock, this appliance has a polar-
ized plug (one blade is wider than the
other). This plug will it in a polarized
outlet only one way. If the plug does
not it fully in the outlet, reverse the
plug. If it still does not it, contact
a qualiied electrician to install the
proper outlet. Do not change the plug
in any way.
www.dimplex.com