Clock/Timer; Clock Setting - Philips FW-R7 User Manual

CLOCK/TIMER

CD REWR ITABLE COMP
STANDBY
ON
CD 1
CD 2
CD 3
CD REC ORD ABL
FW - R7
DISPLAY

Clock setting

It is possible to set the clock by using a time signal which is
broadcast together with the RDS signal. This only works if the
RDS station is sending this time signal.
Automatic clock setting
1 Tune to an RDS station (see "Tuner").
2 Press CLOCK/TIMER on the set for more than 3 seconds.
blinks for a maximum of 90 seconds.
y
Then the time is displayed.
If is displayed, there is no time signal
transmitted. In that case you have to tune to another
RDS station or set the clock manually.
Note: The time signal broadcasted from certain RDS stations
may not always be accurate. If you find there a
discrepancy in clock time, set your clock manually and
the time will then run accurately.
Manual clock setting
1 Press as often as necessary y STANDBY ON on the set to
switch the set to standby.
2 Press CLOCK/TIMER on the set.
3 Rotate JOG CONTROL to select the clock.
is displayed and X starts blinking.
y
28
ATIBLE • 3 CD CHAN GER
ANA LOG
DIG ITAL /
AU X
TU NE R
OR
iR SE NS
S/ TA
NE W
RD S
ER
K/ TIM
CL OC
E MIN I HIF I SYS TEM
CD TE XT
LO SE
OP EN /C
4 Press YES to confirm the selection.
The day of the week digit blinks.
y
5 Rotate JOG CONTROL to set the day.
6 Use ! SEARCH or ⁄ SEARCH on the set to move from
day of the week to hour.
7 Rotate JOG CONTROL to set the hour.
8 Repeat steps 6 and 7 to set the minutes.
9 Press YES to confirm the settings.