Public Key Configuration Examples; Configuring The Public Key Of A Peer Manually - H3C S9500E Series Security Configuration Manual

To do...
2. Display the public keys of the
peers

Public key configuration examples

By default, Ethernet, VLAN, and aggregate interfaces are in the state of DOWN. To configure such an
interface, use the undo shutdown command to bring it up first.

Configuring the public key of a peer manually

Network requirements
Device A is authenticated by Device B when accessing Device B, so the public key of Device A
should be configured on Device B in advance.
In this example:
•
RSA is used.
•
The host public key of Device A is configured manually on Device B.
Figure 34 Network diagram for manually configuring the public key of a peer
Configuration procedure
Configure Device A
1.
Create RSA key pairs on Device A.
<DeviceA> system-view
[DeviceA] public-key local create rsa
Warning: The local key pair already exist.
Confirm to replace them? [Y/N]:y
The range of public key size is (512 ~ 2048).
NOTES: If the key modulus is greater than 512,
It will take a few minutes.
Press CTRL+C to abort.
Input the bits of the modulus[default = 1024]:
Generating Keys...
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++++++++++++++++++++++++++++++++
++++++++++++++++++++++++++++++
Use the command...
display public-key peer [
brief | name publickey-name ]
114
Remarks