Specifications - Integra MZA-4.7 Service Man

SPECIFICATIONS

Amplifier Section
Rated Output Power (FTC)
Front L/R: 50 watts minimum continuous power
per channel, 8 ohm loads, 2 channels
driven at 1 kHz, with a maximum total
harmonic distortion of 0.05%
THD (Total Harmonic 0.05% (Power Rated)
Distortion) 0.05% (1kHz, 1W)
Damping Factor 60
Input Sensitivity and
Impedance 720 mV/22 k ohm (Unbalanced)
Preamplifier Output
Level and Impedance
( Z1 - Z4 L/R) +16 dB / 680 ohm
Frequency Response 20 Hz - 50 kHz/0 dB - 3 dB
Tone Control ±10 dB, 100 Hz (BASS)
±10 dB, 10 kHz (TREBLE)
Signal to Noise Ratio 95 dB (S1, IHA-A)
Speaker Impedance 6 ohm - 16 ohm
Video Section
Input Level & Impedance
(S1 - S8) 1 Vp-p/75 ohm (Composite)
Buffered Video Output
Level and Impedance (S1
- S8) 1 Vp-p/75 ohm (Composite)
Output Level &
Impedance (Z1 - Z4) 1 Vp-p/75 ohm (Composite)
General
Power Supply AC 120 V, 60 Hz
Power Consumption 4.0 A
Standby Power
Consumption 21.4 W
Dimensions
(W H D) 17-1/8"
Weight 27.8 lbs.
Video Inputs
Composite S1 - S8
Video Outputs
Composite Z1 - Z4
Audio Inputs
Analog Inputs S1 - S8
Audio Outputs
Zone Pre Output Z1 - Z4
Speaker Outputs Z1 - Z4 (L/R)
Interface
IR Output A, B, IR1, IR2 - 3.5mm phone Jack
Expansion Bus Input & Output - 34 way 0.1 " Double Row
Header
12V DC 1 Amp Power Two DC power sockets, Center positive
(2.1mm pin diameter)
RS232 One DB9 - 9600 Baud
USB One : USB mini-B 5 pin
Controller Two: 4 way terminal blocks (0V, IR, 12V
& Data)
Amp On Control One: 7 way terminal plug with Amp ON 1
- 4 and #
One Page Preset Contact closure Input -
PG
Specifications and features are subject to change without
notice.
MZA-4.7
5-5/8" 15-13/16"