Philips MCP9350i Service Manual page 55

12.14. PSU
12.14.1. PSU Removal
1. Remove the top cover. See paragraph 12.1.1.
2. Remove the main bezel. See paragraph 12.2.1.
3. Remove the HDD subassembly. See paragraph 12.3.1.
4. Remove the ODD. See paragraph 12.4.1.
5. Remove the riser card subassembly. See paragraph 12.5.1.
6. Remove the CPU heat sink. See paragraph 12.15.1.
7.
Remove the motherboard subassembly. See paragraph 12.16.1.
8. Remove cable ties (1) from the PSU cables. See Figure 12.14-1.
9. Remove the mounting screw (2) from the PSU. See Figure 12.14-2.
10. Slide the PSU towards the front of the chassis to release it from the locking tabs.
11. Remove the PSU from the chassis.
12.14.2. PSU Re-Assembly
To re-assemble the PSU, do all processes described in paragraph 12.14.1 in reverse order.
Note: The torque setting required for the PSU mounting screw (2) is 8kg-cm
Note: Fit replacement cable ties after re-assembly.
1
1
Figure 12.14-1
Hardware Repair MCP9350i 12.
2
Figure 12.14-2
EN 55