Philips MCP9350i Service Manual page 51

12.11. Card Reader
12.11.1. Card Reader Subassembly Removal
1. Remove the top cover. See paragraph 12.1.1.
2. Remove the main bezel. See paragraph 12.2.1.
3. Remove the HDD subassembly. See paragraph 12.3.1.
4. Disconnect the cable (1) from the rear of the card reader board. See Figure 12.11-1.
5. Remove the mounting screw (2) from the card reader subassembly. See Figure 12.11-2.
6. Slide the card reader subassembly out from the chassis and remove it.
12.11.2. Card Reader Subassembly Re-Assembly
To re-assemble the card reader subassembly, do all processes described in paragraph 12.11.1 in reverse order.
Note: The torque setting required for the card reader subassembly mounting screw (2) is 6kg-cm
12.11.3. Card Reader Board Removal
1. Remove the card reader subassembly. See paragraph 12.11.1.
2. Remove the 3 mounting screws (3) from the card reader board. See Figure 12.11-3.
3. Remove the card reader board from the card reader cage.
12.11.4. Card Reader Board Re-Assembly
To re-assemble the card reader board, do all processes described in paragraph 12.11.3 in reverse order.
Note: The torque setting required for the card reader board mounting screws (3) is 6kg-cm
1
Figure 12.11-1
3
3
3
Figure 12.11-3
Hardware Repair MCP9350i 12.
2
Figure 12.11-2
EN 51