9.5.
System Recovery
A system restore is used to return the set to its original software configuration. If a later software built is available, this built should be
installed on the system instead (see Chapter 13 – Software Re-installation)
1.
In Windows XP select: Start > All programs > System Recovery > System Recovery . (Alternatively, press the F11 key during
boot sequence).
2.
Follow the on-screen instructions to perform a system recovery without performing a format, (operations from this point are carried
out in DOS mode).
Software Update and Repair
Figure 9.5-1
Figure 9.5-2
MCP9350i
9.
EN 19