Philips MCP9350i Service Manual page 50

EN 50 12.
12.10. SW Board & RF Receiver
12.10.1. SW Board & RF Receiver Removal
1. Remove the top cover. See paragraph 12.1.1.
2. Remove the main bezel. See paragraph 12.2.1.
3. Disconnect all cables (1) from the SW board & RF receiver. See Figure 12.10-1.
4. Remove the 4 mounting screws (2) from the SW board & RF receiver. See Figure 12.10-1.
5. Remove the SW board & RF receiver from the chassis.
Note: The RF receiver may be removed from the SW board by carefully pulling it out of its connector.
2
2
12.10.2. SW Board & RF Receiver Board Re-Assembly
To re-assemble the SW board & RF receiver, do all processes described in paragraph 12.10.1 in reverse order.
Note: The torque setting required for the SW board & RF receiver mounting screws (2) is 6kg-cm
MCP9350i Hardware Repair
2 1
2
Figure 12.10-1
1