First-Time Dvd/Vcr Setup 15 - Philips DVD740VR Owner's Manual

DVD740VR 4/12/02 12:08 PM
Before turning on your DVD/VCR, make sure batteries are in the
remote control and the DVD/VCR and TV are connected correctly.
You cannot program channels if you are using a Cable Box or a
Direct Broadcast System.
1
Press VCR, then press POWER
appear briefly on the front of the DVD/VCR. The green
VIDEO light, the VCR/TV light, and the Power light will
appear on the front of the DVD/VCR.
2
Turn on the TV. Set it to the same channel as the
CH3/CH4 switch on the back of the DVD/VCR. The
display shown below will appear. (If the display does not
appear, check your hookups, then follow the steps on page
24 to set up channels and page 29 to select a language.)
SELECT op
ENGLISH
ESPAÑOL
MAKE SELECTION OR
PUSH MENU TO CONTINUE
3
Within 60 seconds, press PLAY B (o) or STOP C
(p) to select English or Spanish as the language for
VCR on-screen displays and menus.
4
Press DISC/MENU.
CONNECT ANTENNA OR CABLE
TO VCR
THEN...
PUSH CH UP KEY
OR...
FOR PLAY ONLY - PUSH STOP
5
Within 60 seconds, press CHANNEL/SKIP G (o)
to begin automatic channel programming. AUTO
CH PROGRAMMING IN PROCESS PLEASE WAIT will
appear on the TV screen. The DVD/VCR will memorize all
available channels. When all channels are memorized,
CHANNELS ARE SET will appear on the screen briefly,
then TV programming will appear.
These channels will be available when you want to watch
TV while in VCR mode. To put the DVD/VCR in VCR
mode, press OUTPUT SELECT so the green VIDEO light
appears. Then press VCR/TV so the VCR/TV light appears.
Press the VCR button, then use CHANNEL/SKIP
j/i (p/o) and the Number buttons to select a TV
channel for viewing.
Page 15
y y
. "P-ON" will
ON

First-time DVD/VCR Setup 15

2
MARKER
SETUP
REC/OTR
5
TITLE
DVD
4
MENU
STOP
REW
+ 10
SEARCH MODE DISPLAY
TIME SEARCH
Helpful Hints
• To skip this feature and play a tape
immediately, insert a tape with its
record tab removed.
• To skip step 3, press DISC/MENU.
All on-screen displays will be in
English. To skip step 5, press STOP
C (p). Channels will not be pro-
grammed, and CHANNELS NOT
SET will appear on the screen.
• If you try to program channels
when there is no antenna or Cable
TV signal connected to the ANT-IN
jack of the DVD/VCR, programming
will appear to take place, but even-
tually a NO TV SIGNALS message
will appear. Connect an antenna or
Cable TV signal to the DVD/VCR's
ANT-IN (Antenna In) jack and press
CHANNEL/SKIP G (o) again. If
channel programming does not
resume, follow the steps on page 24.
• You may need to repeat the steps
on this page if the power fails.
Turn on the TV.
POWER 1
AUDIO SUBTITLE ANGLE
REPEAT REPEAT
A-B
CHANNEL/SKIP
CLEAR
MODE RETURN
OUTPUT SELECT
VCR
DISC
OK
3
PLAY
FF
PAUSE
TIMER SET
1 2 3
VCR/TV
4 5 6
MEMORY
8
7 9
SPEED
0
ZOOM SLOW
STATUS/EXIT