First-Time Dvd/Vcr Setup - Philips H982NUD User Manual

H982NUD_EN1 3/2/06 6:56 PM Page 16

16 First-time DVD/VCR Setup

Before turning on your DVD/VCR, make sure batteries are in the
remote control and the DVD/VCR and TV are connected correctly.
You cannot program channels if you are using a Cable Box or a
Satellite Receiver.
These menus may not appear if you have already turned
on the DVD/VCR.
1
Turn on the TV. Set it to channel 3 or 4 or its
AUDIO/VIDEO IN channel, depending on how you
connected the DVD/VCR to a TV.
2
Press VCR, then press STANDBY-ONy. VCR light will
appear on the front of the DVD/VCR.The display shown
below will appear.
These menus may not appear if you have already turned on
the DVD/VCR.You may have turned on the DVD/VCR
before to find the Audio/Video In channel of the TV, for
example. If so, follow the steps on page 21 to set up
channels and page 23 to select a language for the VCR
menus.
LANGUAGE SELECT
BENGLISH
FRANCAIS
ESPAÑOL
PUSH B
3
Press K or L to select ENGLISH, FRANCAIS
(French) or ESPAÑOL (Spanish) as the language for
VCR on-screen displays and menus. Then, press B. The
display shown below will appear.
AUTO SET UP
PUSH B
4
Press B to begin channel programming. AUTO
SETUP will flash on the TV screen during the channel
search.The DVD/VCR will memorize all available channels.
When channel programming is complete, the lowest
available channel will appear on the TV.
These channels will be available when you want to watch
TV while in VCR mode.To put the DVD/VCR in VCR
mode, press VCR so VCR light appears. Use SKIP ∑/CH K
or SKIP w/CH L to select memorized channels.To select
non-memorized channels, use the Number buttons.
[ON]
1
Turn on the TV.
STANDBY-ON
SEARCH MODE DISPLAY
REPEAT REPEAT AUDIO
A-B
SUBTITLE ZOOM ANGLE SKIP / CH
RETURN TITLE CLEAR/RESET SLOW
VCR VCR/TV DVD
DISC/VCR SYSTEM
3-4
MENU MENU
OK
STOP PLAY PAUSE
TIMER SET MARKER RECORD
SPEED
1 2 3
4 5 6 7
8 9 0 +10
Helpful Hints
• To skip this feature and play a
tape immediately, insert a tape
with its record tab removed.
• If you like to skip step 4, press
DISC/VCR MENU as soon as the
search begins.The DVD/VCR will
stop the channel search, and the
VCR menus and displays will be
in English.
• If you try to program channels
when there is no antenna or
Cable TV signal connected to the
ANT-IN jack of the DVD/VCR,
programming will stop.AUTO
SET UP will stop flashing.
Connect an antenna or Cable TV
signal to the DVD/VCR's
ANT-IN jack and press B again.
• Repeat this process if the power
fails.
2