Table of Contents
Advertisement
•
Now, level the printer front to rear by placing the level on the lower metal rail behind the print table, adjust
the printer feet as needed to level the printer. Remove level from printer when completed.
4. CONNECT POWER
•
Plug power cord into a surge suppressor connected to a wall outlet
•
If your area experiences intermittent or unreliable power issues, consider using a UPS (uninterruptable
power supply).
•
Plug the other end of the power cord into the power entry module in the rear of the printer. NOTE: Powering
up is a 2-step process.
•
First, turn ON the printer using the I/O switch in the back of the printer.
•
CAUTION - Make sure you removed the 2 retainer brackets and bubble level before powering up the printer
to avoid damaging the printer.
panel will light up and the printer will start its power up sequence.
•
DO NOT plug the USB cable into the printer or PC at this time.
5. BEFORE INK FILL CHECK
•
Before Ink is added to the printer, perform a quick check of printer operation.
1) Power up the printer (with switch on back + pressing <POWER> on control panel)
2) During power-up initialization, observe printer table and carriage movement as the carriage moves right
and then back to its home position.
STOP
Download the User Manual and Rip software at
Then, press the <POWER> key on the printer's front control panel. The LCD
STOP! Before going further, contact your printer supplier to schedule your
setup and training session with your certified technician.
www.Anajet.com/downloads
18
Advertisement
Table of Contents
