Yamaha Clavinova CLP-265GP Service Manual page 16

CLP-265GP
27-6 Hammer, White (Black) Key
After a key has been removed, push the key spring down
once to take it out of the hook. (Fig.29)
Place the keyboard assembly upside down and peel away
the stopper L88-W. The hammer of the white key can
then be removed. (Fig.30)
* The hammer of the black key can then be removed in the
same manner.
28. Assembling the GH3 Keyboard
28-1 Hammer, White (Black) Key
Place the keyboard assembly upside down, insert a
hammer assembly into the frame, and put the stopper
L88-W on. (Fig.31)
28-2 Key spring
Place the keyboard assembly right side up, and fix a key
spring to the frame by setting it at the slit and pushing it
down once. (Fig.32)
* Be careful of the direction of the spring. It should be
installed with its projecting end facing upward. (Fig.32-1)
28-3 White (Black) key
After a key has been fit to part [F] and the key guide,
make sure that the spring is fixed to the key.Then press
part [E] of the key down. (Fig.33)
28-4 GH3_EBUS circuit board L
Tighten the five (5) screws marked [260A] and the screw
marked [262A] to fix the GH3_EBUS circuit board L.
(Fig.26)
28-5 GH3_EBUS circuit board M
Tighten the four (4) screws marked [260B], the screw
marked [262A] and the screw marked [262B] to fix the
GH3_EBUS circuit board M. (Fig.26)
28-6 GH3_EBUS circuit board H
Tighten the five (5) screws marked [260C] and the screw
marked [262B] to fix the GH3_EBUS circuit board H.
(Fig.26)
Key Spring
16
Hook
(Fig.29)
Hammer, White Key
Stopper L88_W
(Fig.30)
Stopper L88_W
(Fig.31)
Hook
(Fig.32)
White Key
Key Guide
[F]
(Fig.33)
Hammer, White Key
Slit
Flame
Upside
Spring
Frame
Up
(Fig.32-1)
[E]
Key Spring