Remove The Key Cover Assembly. (See Procedure - Yamaha Clavinova CLP-265GP Service Manual

CLP-265GP
22-9 Arm Assembly L
22-9-1 Remove the three (3) screws marked [S09A], the six (6)
screws marked [S06A] and the two (2) screws marked
[6A]. The arm assembly L can then be removed. (Fig.20)
22-10 Arm Assembly R
22-10-1 Remove the three (3) screws marked [S09B], the six (6)
screws marked [S06B] and the two (2) screws marked
[6B]. The arm assembly R can then be removed. (Fig.20)
23. Back Top Board Assembly
(Time required: About 9 minutes)
23-1 Remove the top board assembly (L). (See procedure 2.)
23-2 Remove the support bar assembly. (See procedure 17.)
23-3 Remove the speaker grille assembly and the partition
assembly C. (See procedure 18.)
23-4 Remove the three (3) screws marked [S09A] and the
three (3) screws marked [S09B]. (Fig.20)
23-5 Remove the nine (9) screws marked [S07]. The back top
board assembly can then be removed. (Fig.20)
24. Front Rail Assembly
(Time required: About 10 minutes)
24-1 Remove the top board assembly (L) . (See procedure 2.)
24-2 Remove the top board assembly (S). (See procedure 3.)
24-3

Remove the key cover assembly. (See procedure 5.)

24-4 Remove the panel assembly. (See procedure 10.)
24-5 Remove the end block assemblies L and R.
(See procedure 12.)
24-6 Remove the keyboard assembly. (See procedure 15.)
24-7 Remove the two (2) screws marked [6A], the two (2)
screws marked [6B] and the seven (7) screws marked
[S06C]. The front rail assembly can then be removed.
(Fig.20)
[S2]
Adjuster
[S2]: Pan Head Screw 6.0X20 MFZN2B3 SW (WF003300)
14
[S2]
Pedal Box Unit
(Fig.21)
25. Pedal Box Unit, Pedal Assembly
(Time required: About 5 minutes)
25-1 Rotate the adjuster until it comes off the floor surface.
25-2 Disconnect the PK-LF cable. (Fig.10)
25-3 Remove the four (4) screws marked [S2]. The pedal box
unit can then be removed. (Fig.21)
25-4 Remove the nine (9) screws marked [5]. The pedal
assembly can then be removed. (Fig.22)
Pedal Assembly
[5]: Bind Head Tapping Screw-1 4.0X14 MFZN2W3 (WE971900)
(Fig.22)
Be sure to position the keyboard
side on the bottom.
(Fig.23)
[S1]
Leg Assembly
[S1]: Pan Head Screw 6.0X40 MFZN2B3 SP (WE995700)
(Fig.24)
[5]
[5]
[S1]