Download Print this page

Cleaning And Maintenance - Russell Hobbs RHMF10 Instruction Manual

18” mist fan

Advertisement

8. Unplug your fan from the electric outlet when not operating, moving it from one room to another,
installing or uninstalling it's parts and before cleaning.
9. Supervision is needed when this product is used anywhere near children. The appliance is not intended for
use by children or other persons without assistance or supervision if their physical, sensory or mental
capabilities prevent them from using it safely.
10. For safety reasons, please disconnect the plug from the electrical outlet. Do not pull the plug while the
power is on. Always ensure that the plug is fully inserted into the electric outlet.
11. Never handle the power cord with wet hands as this could result in fire or electric shock.
12. Do not disassemble, repair or modify this product on your own. Warranty will be voided if repair is carried
out by an unauthorized person/agency.
13. The water safety button will automatically switch off the fan when it runs out of water in the tank.
14. Never forget to add water for permanent operation of your fan.
15. Do not put any sundries into guard and mist-prayed hole to avoid destroying the fan.
16. Do not stick any finger or objects into the guard.
17. If the supply cord is damaged, it's service agent or a similarly qualified person must replace it in order to
avoid any hazard.
18. This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they are under supervision or given
instructions concerning use of the appliance by a person responsible for their safety.
19. Children should be supervised to ensure that they do not play with the appliance.
Cleaning and Maintenance
1. Pull out the power cord plug from the electrical outlet and make sure that your fan is
not operating before cleaning it.
2. Please clean the water tank every two to three weeks, and clean the flume every week.
3. Take out the water tank when cleaning it, pull plastic tube out of the atomizing cup
properly, then take out the atomizing cup and clean it.
4. Use a dry cloth to absorb water remaining when cleaning the ultrasonic atomizer, and
dry it using a piece of soft cloth. Or use mild detergent to clean the ultrasonic atomizer if it
is dirty.
5. Please add a few drops of lubricant to the motor shaft after cleaning to extend motor
life every year.
6. Pack this appliance properly and store it in a cool dry place if you are not using it.

Advertisement

loading