Advertisement
Assembling the Rear Guard
1. Take out the blade cap from the shaft turning it clockwise.
2. Take out the rear guard mounting nut turning it anti-clockwise.
3. Insert the rear guard into the motor matching 3 rods on the front side of the motor (the handle will direct
upwards) to 3 holes of the rear guard.
4. Fasten the rear guard tightly by turning the guard mounting nut clockwise.
Assembling the Fan Blade
1. Insert the blade to the shaft and ensure the pin enters the blade slot.
2. Tighten the blade using the blade cap turning anti-clockwise in the direction" TIGHT" arrow on it.
Note: Proper assembly of the blade is of great importance. Otherwise, the blade spins in the air and damages
the appliance.
Assembling the Front Guard
1. Fix the front guard with the logo in the upright position on the rear guard. Make sure that they are
connected from the upper side.
2. Take the front guard rim to set in the groove and fix it with screwdriver.
Note: Do not operate the fan without assembling the guards properly and tightly.
Technical Specifications
Rated Voltage: 230V~
Rated Frequency: 50Hz
General Power: 110W
Max Mist Capacity: 200ml/h
Blades Size: 450mm
Water Tank Capacity: 1500m
Advertisement
