Indesit VIA640C Service Information page 9

Indesit Company
Ventilation
• The hob should be positioned at least 40 mm away
from the back wall or any other vertical surface in
order to allow for correct ventilation and to prevent
the surfaces around the appliance from overheating.
• Ensure that a minimum distance of 20 mm is
maintained between the installation cavity and the
cabinet underneath. See Fig. 2.
• Kitchen cabinets adjacent to the appliance and taller
than the top of the hob must be at least
600 mm from the edge of the hob.
Fixing
Very important: It is vital that you ensure the glass ceramic
hob is built into a perfectly flat supporting surface.
Any deformities due to improper fixing could alter the
characteristics of the hob and compromise its performance.
The thickness of the supporting surface should be taken into
account when choosing the length of the screws for the fixing
hooks:
• 30 mm thick - 17.5 mm screws
• 40 mm thick - 7.5 mm screws
Fix the hob as follows: -
• Use short flat-bottomed screws to fix the 4 alignment
springs in the holes provided at the central point of each
side of the hob.
• Place the hob in the cavity, make sure it is in a central
position and push down on the whole perimeter until the
hob is stuck to the supporting surface.
• For hobs with raised sides - after inserting the hob into its
cavity, insert the 4 fixing hooks (each has its own pin) into
the lower edges of the hob, using the long pointed screws
to fit them into place, until the glass is stuck to the
supporting surface.
Service Manual UK
UNDERSIDE OF HOB
9 of 29
Fig. 2
min. 20 mm
COMPARTMENT
min. 40 mm
min. 20 mm
FAN-ASSISTED
OVEN
min. 40 mm
FRONT SIDE OF HOB
SUPPORTING
SURFACE
English