100w flush mount audio amplifier
with bluetooth, cat5 audio and tos-link
digital input source (6 pages)
Summary of Contents for Channel Vision A500
Page 6
Note: No signal connection cable is provided with the A500 amplifier since the length of cable is specific to each A500 installation. A shielded RCA type coaxial cable or a shielded two-conductor wire with RCA type connectors is required for connection of the A500 to the audio system.
Page 9
Degrees. What do these scales represent? dB (decibel), as used on the A500, is a unit used to describe relative volume. The most important thing to know here is that a 1db difference in sound level is just barely noticeable and that 3db is only a modest change in perceived sound level.
Page 15
A Short Primer on Low Frequency Acoustics The A500 controls will allow you to make the best of virtually any installation. If you feel uncomfortable with setting up your A500 after reading through this manual, please contact Channel Vision technical support at 714.424.6500.
Need help?
Do you have a question about the A500 and is the answer not in the manual?
Questions and answers