Example - OSEE IRS3232 User Manual

Network Control
Type a new name for the button in the name field. For example, type
"CCTV1" as the name of SRC1 button, after modifying the renaming, click
OK button
Figure 6.2-10.
Figure 6.2-10 Rename the Button Name
Likewise, rename the other signal buttons as you wish.
 The value of Protect must be set as Disable when you switch the signal
source for an output destination in REMOTER page, otherwise, you can't
make it successfully, but the rename operation is without this limitation.

6.3 Example

For example: there is a complex system with one remote control panel and two
routers, use the LEVEL1 and the LEVEL2 button of the remote control panel to
control these routers.Set the device settings as shown in Table 6.3-1:
Table 6.3-1 The Settings Information to the Devices
Type
Remote Control Panel OSEE-Panel-0001
Router
Router
Use the network control page to set the information. The Level setting is shown
as in Figure 6.3-1:
to save the modification, the result is as shown in
Name
OSEE-Router-0000 192.168.1.86
OSEE-Router-0001 192.168.1.87
24
IP Address Level
192.168.1.7 --
LEVEL1
LEVEL2