Network Control
Classify Items
Gateway
Alarm IP
Alarm Port
Remember to enter a new IP address into your Web browser's address bar,
if the device's IP address has changed.
The value of Protect must be set as Disable when you switch the signal
source for an output destination in REMOTER page, otherwise, you can't
make it successfully.
Color settings
3.
It is used to set up the color information for detecting the signal source
(Detection Enable) and not detecting the signal source (Detection Disable),
as shown in Figure 6.2-4, it contains the following items:
Figure 6.2-4 Router Page-Color Settings
Enable Function
Detection
Function
Detection
Enable(detecting
signal source)
Default Value
192.168.1.1
192.168.1.100
8000
Type
Items
Current
Output
Source
Normal
Description
It displays the IP address of the
gateway.
It displays the IP address which is
used
to
receive
information.
It displays the communication port
which is used to receive the alarm
information.
Description
Select a color for a signal
source when it is the current
output.
Select a color for a signal
source whose status is normal
20
the
alarm