Table of Contents
Advertisement
Network Control
In STATUS page, check the information of router in "ROUTER" page, and
check the information of remote control panel in "REMOTER" page.
6.2.2 REMOTER
It will introduce REMOTER tab in this section.
The REMOTER tab is used to set the signal source for the output
destination connecting to the buttons of the IRS series devices.
Click REMOTER, it displays the page as shown in Figure 6.2-6:
The default signal source for each output destination (DEST*) is SRC1.
The buttons in this control panel are in accordance with the buttons of the
remote control panel, you can do the following two operations in this page:
Signal source switch: you can assign a signal source for your
destination output channel.
At first, click the output destination (DEST*) button, then click a signal
source (SRC*) button for it, thus to realize the assignment.
For Example:
The original signal source for DEST1 is SRC1, switch the signal source to
SRC10, the instructions are as below:
Figure 6.2-6 Remoter Page
22
Advertisement
Table of Contents
