Device Application
Connection principle: use the Ethernet interface to connect the router
and the remote control panel.
The IP address should not be repeatable in a network system.
5.2 Operations
You can do the following operations to a router before operating:
Step 1 Connect the input resource signals INPUT at the rear panel of the
router.
Step 2 Connect the output lines to OUTPUT at the rear panel of the router.
Step 3 Connect the power lines.
Step 4 Connect the reference voltage line to REF at the rear panel of the
router.
Step 5 Connect the routers and the remote control panels through
ETHERNET using a switch.
Figure 5.1-2 A Complex System
16