Power Seats; Heated Seats - Jeep 2017 PATRIOT User Manual

Power Seats

Some models may be equipped with a power
driver's seat. The power seat switch is located
on the outboard side of the seat near the
floor. Use the switch to move the seat up,
down, forward, rearward, or to tilt the seat.
Power Seat Switch
20
WARNING!
• Adjusting a seat while driving may be
dangerous. Moving a seat while driving
could result in loss of control which
could cause a collision and serious in-
jury or death.
• Seats should be adjusted before fasten-
ing the seat belts and while the vehicle
is parked. Serious injury or death could
result from a poorly adjusted seat belt.
CAUTION!
Do not place any article under a power seat
or impede its ability to move as it may
cause damage to the seat controls. Seat
travel may become limited if movement is
stopped by an obstruction in the seat's
path.
Adjusting The Seat Forward Or Rearward
The seat can be adjusted both forward and
rearward. Push the seat switch forward or
rearward. The seat will move in the direction
of the switch. Release the switch when the
desired position has been reached.
Adjusting The Seat Up Or Down
The height of the seats can be adjusted up or
down. Pull upward or push downward on the
seat switch. The seat will move in the direc-
tion of the switch. Release the switch when
the desired position is reached.
Tilting The Seat Up Or Down
The angle of the seat cushion can be adjusted
in four directions. Pull upward or push down-
ward on the front or rear of the seat switch,
the front or rear of the seat cushion will move
in the direction of the switch. Release the
switch when the desired position is reached.

Heated Seats

On some models, the front driver and passen-
ger seats may be equipped with heaters in
both the seat cushions and seatbacks. The
controls for the front heated seats are located
on the center instrument panel area.
You can choose from HI, LO or OFF heat
settings. Amber indicator lights in each
switch indicate the level of heat in use. Two
indicator lights will illuminate for HI, one for
LO and none for OFF.