Table of Contents
Advertisement
Auto Atlas-14T Operation panel
Number Display
Displays surface temperature of the roller
and setting values.
In general (when no operation is done
after connecting power), current heat
roller temperature is displayed.
TEMP Button (LED lamp: orange)
LED lamp is turned on and heat roller
temperature is displayed if no button is
pressed after power connection. When
the button is pressed in this state, LED
lamp flickers and turns to temperature
display for the metal roller.
R Margin Button (LED lamp: orange)
The button is used to display mm setting
of the rear film in the direction of the
film. LED lamp is turned on and current
setting is displayed when the button is
pressed once.
L/CUT (LED lamp: green)
This selects whether to perform film
cutting using rotary cutter. LED lamp is
turned on and off whenever the button is
pressed, displaying whether the rotary
cutter is enabled or disabled.
ESC Button
This button is used to cancel any
changes made to settings when various
settings are changed.
ENT Button
This button is used to switch to setting
mode or decide to apply the changed
value.
START/STOP Button
This button starts or stops the device.
Ready Lamp (red)
This lamp is turned on when laminate work
can be performed with consideration on
roller surface temperature.
The lamp will flicker when there is difference
between
roller
surface
temperature
setting
(while
preheating
connection, etc.).
F Margin Button (LED button: orange)
This button issued to display remaining
mm of the front film in the direction of
the film.
LED lamp is turned on and current
setting is displayed when pressed once.
Option Button (LED lamp: orange)
Number of papers to be processed is
displayed when the product is at a stop,
performing countdown from the number of
papers. When setting is 「0」, papers will be
supplied until they run out.
Setting value is reset when power is turned
off.
△ Button
▽ Button
These buttons are used to increase or
decrease values during setting.
W/CUT (LED button: green)
It can elevate / descend the paper
supply and operation of motor in
combination with other buttons.
Refer to page 9 for details.
Operation Display Lamp (LED lamp:
green)
This lamp is turned on during operation
of the device.
and
after
power
8
Advertisement
Table of Contents
