Table of Contents
Advertisement
Auto Atlas-14T Basic operation of operation panel
Basic operation of this product is done by combining [W/CUT] with other buttons.
Auto Atlas-14T Error display of operation panel
LCD display
※ Contact our company or the seller when other error occur.
About setting and display
To adjust temperature of heat roller
Initial setting: 100˚C
Adjustable range: 10-120˚C
1. Turn on the TEMP LED and press [ENT] button.
2. Value on the display will flicker. (Showing that you entered
setting mode)
3. Press △ and ▽ buttons to set the number within
10~120˚C.
4. When [ENT] button is pressed again, flickering display is
changed to on and setting is ended.
※ Press [ESC] button to stop during setting.
※ Setting is remembered when power is turned off.
To adjust temperature of metal roller
Initial setting: 115˚C
Adjustable range: 10-120˚C
1. Press [ENT] button while TEMP LED is flashing
2. Value on the display will flicker. (Showing that you entered
setting mode)
3. Press △ and ▽ buttons to set the number within
10~120˚C.
4. When [ENT] button is pressed again, flickering display is
changed to on and setting is ended.
※ Press [ESC] button to stop during setting.
※ Setting is remembered when power is turned off.
9
Elevation of paper plate
Operation
of
paper
supply motor
Operation
of
main
body motor
Reason for stopping and solution
Jam sensor detection [AOP]
The processed material does not come out of the back and is caught
inside the product.
Open the top unit of this product and slowly close while taking the
material out.
※ Press [ESC] to cancel panel display.
The top unit is open. [AOP]
The top unit of this product is not closed properly.
Since processing cannot be done as is, open the unit and close it again.
Make sure that it is not opened by pulling the handle before continuing
with the processing.
※ Press [ESC] to cancel panel display.
Processing is finished for the number of paper set. [ A
If the number of processed paper is set, the product will stop once
processing is done according to the number setting.
※ Press [ESC] to cancel panel display.
Film end detection [ F L 1 ]
Since top laminate film or bottom laminate film is used up, turn the
power off and set new films.
※ Press [ESC] to cancel panel display.
Descending of paper
plate
Operation of paper
plate motor
Reverse rotation of
main body motor
]
Power is connected
and surface
temperature of heat
roller is displayed
[100]=100˚C
Power is connected
and surface
temperature of metal
roller is displayed
[115]=115˚C
Advertisement
Table of Contents
