Table of Contents
Advertisement
To make margin setting (front side of direction of film)
Initial setting: 3mm
Adjustable range: 0-50mm
1. Turn on the F margin LED and press [ENT] button.
2. Value on the display will flicker. (Showing that you entered
setting mode)
3. Press △ and ▽ buttons to set the number.
4. When [ENT] button is pressed again, flickering display is changed
to on and setting is ended.
※ Press [ESC] button to stop during setting.
※ Setting is remembered when power is turned off.
To make margin setting (back side of direction of film)
Initial setting: 3mm
Adjustable range: 0-50mm
1. Turn on the R margin LED and press [ENT] button.
2. Value on the display will flicker. (Showing that you entered
setting mode)
3. Press △ and ▽ buttons to set the number.
4. When [ENT] button is pressed again, flickering display is changed
to on and setting is ended.
※ Press [ESC] button to stop during setting.
※ Setting is remembered when power is turned off.
To set the number of papers to be laminated
Initial setting: 0 sheet, Adjustable range: 0-250 sheets
1. Turn on the option LED and press [ENT] button.
2. Value on the display will flicker. (Showing that you entered setting
mode)
3. Press △ and ▽ buttons to set the number.
4. When [ENT] button is pressed again, flickering display is changed to on
and setting is ended.
※ Press [ESC] button to stop during setting.
※ If setting value is 0, papers will be supplied until all papers on the paper
plate are used up. For values other than 0, paper supply is finished once
the number of papers set here is reached.
※ This setting value can be checked by pressing [Option] button when the
machine is at a stop.
Remaining number of papers to be processed can be seen if pressed
during operation of the machine.
Caution
The number displayed refers to the number of papers supplied, not the
number of papers for which laminate is complete.
To find out how many papers have been laminated so far
Initial value upon power connection: 0 sheet
1. Press [ESC] button while pressing [Option] button.
2. Value on the display will flicker and show the number of papers
process after power connection.
※ Displayed number refers to the number of papers for which
laminate is complete.
※ It does not show the number of papers processed before power
connection.
To delete the number of laminated papers
Initial value upon power connection: 0 sheet
1. Press [ENT] button while pressing [Option] button.
2. The count is deleted and [0] is displayed.
※ Displayed number refers to the number of papers for which
laminate is complete.
※ It does not show the number of papers processed before power
connection.
Caution
It is displayed as [0] once deleted and cannot be cancelled.
F margin LED is
turned on and
number is
displayed
[ 3]=3mm
R margin LED is
turned on and
number is
displayed
[ 5]=5mm
Option LED is
turned on and
number of papers
is set [250]=250
sheets
[ESC] is pressed
while pressing
[Option] button
[125]=125 sheets
[ENT] is pressed
while pressing
[Option] button
[ 0]=0 sheet
10
Advertisement
Table of Contents
