Setting And Processing Of Laminate Film - LAMI AUTO ATLAS-14T Instruction Manual

Setting and Processing of Laminate Film

Setting and Processing of Laminate Film
Refer to the following to set the laminate film.
※ Since it is dangerous nearby during film setting, turn the power OFF and cool the rollers for 10
minutes before setting.
[ 1 ] Check the installation point of this product.
① This product must have the bottom laminate film stand pulled down.
Film setting can be made difficult by the stand depending on the installation position.
[ 2 ] Set the top laminate film.
① Look at the tip of the film from the front and position the paper tube holder with spring
on the right side. (For external type)
② Since left side of the film set bracket is fixed, set the left side first.
Right spring paper
tube holder
③ Pull the film to the metal roller and slowly open the top unit of main body to insert the film so
it comes out of the outlet.
[ 3 ] Set the bottom laminate film.
① Pull the brackets on left and right sides of direction board to separate the direction board.
During installation, make sure that the film is inserted into the bracket gap inside the circle in
the figure on the right.
13
metal roller
Allow the film to come
out of the outlet