Troubleshooting For Failures; Power Does Not Turn On Or Machine Does Not Function; Top Unit Cannot Be Closed - LAMI AUTO ATLAS-14T Instruction Manual

Troubleshooting for Failures

The following must be kept in mind while using this product

Power does not turn on or machine does not function

Insert outlet plug and check power switch
Make sure that the outlet plug is correctly connected.
Check whether power switch on the rear side is turned on.
If the power cord is disconnected by scratch, contact our company or the seller.
Check disconnection of fuse
If it is disconnected, replace with a new fuse with identical spec.
When the same symptom continues to occur, contact our company or the seller.
Heater or light projector is used nearby, or long drum (cord reel) is used
When such products are used, use different power system.
If a drum is used, separate the drum and connect this product.
.
Abnormal sound is created by motor
When abnormal sound is created by the motor, the saw-tooth is damaged or screw is loosened.
Contact our company or the seller.
Setting temperature is not reached
Check the display on the operation panel.
If [READY] lamp flickers, wait until the lamp is turned on.
The top unit is left open
Check whether the handle on the right side of main body is pulled down or in open state.
If the top unit is not closed properly, close it again.
Display on the operation panel is strange.
If text displayed on the operation panel appears as 「0」 or broken, turn off the power and wait
for a moment before applying power again.
If the problem cannot be resolved by reconnecting power, contact our company or the seller.
It malfunctions or power immediately turns off
There is problem in wiring.
Contact our company or the seller.
PCB malfunctions due to static electricity generated inside the machine.
Turn the power off first and then turn it on again.

Top unit cannot be closed

Handle is pulled down.
Lift the handle to remove pressure status and pull down the handle again.
16