Precautions For Installation - Panasonic WV-X6531N Important Information Manual

Precautions for installation

Panasonic assumes no responsibility for injuries or property damage resulting from
failures arising out of improper installation or operation inconsistent with this
documentation.
For information about the installation tasks, refer to the provided Installation Guide.
In order to prevent injury, the product
must be securely mounted to a wall or
ceiling according to Installation Guide.
Power supply
This product has no power switch.
When performing electrical work, make sure the
camera can be turned on and off. When an
Ethernet cable or power cable is connected, the
power is turned on. When the product is sup-
plied, the product will perform panning, tilting,
zooming and focusing.
When cleaning the product, remove the Ethernet
cable or disconnect the power cable from the
main power supply.
Installation area for this product
Select an appropriate place for the installation
area (such as a strong wall or ceiling) in your
particular environment.
• When hanging the camera from a ceiling,
use the WV-Q121B (option) ceiling mount
bracket.
• When installing on a wall, use wall mount
bracket WV-Q122A (option).
• When pendant-mounting on a ceiling on a
bracket that is custom-made, use the
attachment pipe.
• Make sure that the installation area is
strong enough to hold this product, such
as a concrete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• Do not mount the product on a plaster
board or a wooden section because they
are too weak. If the product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced.
When using the camera in combination
with an attachment pipe and attaching to
a locally procured bracket
• Locally procure a M6 eye bolt (stainless
steel).
Recommended tightening torque:
2.45 N·m {1.8 lbf·ft}
• In order to prevent the camera from falling,
procure a bracket that can be attached a
safety wire.
• Connect the M6 eye bolt and locally pro-
cured bracket together with the safety wire.
• Check that the surface that the attachment
pipe and locally procured bracket are to be
attached to can bear the weight of the
bracket and camera.
Mounting method for this product
This product is designed to be used as a pen-
dant mount camera. If the product is mounted
on a desktop or at a slant, it may not work cor-
rectly and its lifetime may be shortened.
Do not place this product in the following
places:
• Locations where a chemical agent is used
such as a swimming pool
• Locations subject to moisture or oil smoke
such as a kitchen
• Locations that have a specific environment
that is subject to an inflammable atmo-
sphere or solvents
• Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic
field is generated
• Locations near coasts directly subjected to
sea breezes, or locations subject to corro-
sive gases such as from hot springs, vol-
canic regions, etc.
• Locations where the temperature is not
within the specified range (
14
page 30)
☞