Table of Contents
Advertisement
Installation Precautions
Note: This camera is only for indoor usage.
1. This device should be mounted and maintained only by an experienced
professional. If in doubt, consult the dealer.
2. Before mounting, determine the suitable location. The device must be
fixed to a wooden or masonry/concrete wall or ceiling using fasteners that
are appropriate for the mounting surface. Do not install on drywalls,
wallboards, or thin plywood. The mounting surface must be capable of
supporting the weight of the device.
3. Do not drill into any pipes or power lines beneath the surface during
mounting holes preparation. Use voltage/metal detector before drilling
any holes to eliminate any such potential risks.
4. Do not hang anything on the device.
5. Mount the device to monitor the most vulnerable areas of your home, such
as front elevations, side access and rear entrance points.
6. It is suggested to mount the device 2.5 m to 4 m above the ground for the
most visibility and the maximum detection range.
7. Do not place the device near high voltage wires or other sources of
electrical interference. Electrical interference may degrade the quality of
the signal.
5
Advertisement
Table of Contents
