Panasonic WV-X6531N Important Information Manual page 23

Hide thumbs Also See for WV-X6531N:
Table of Contents

Advertisement

■ Indicators and buttons
①INITIAL SET switch
Use the INITIAL SET switch to reset the settings of the camera to the default.
IMPORTANT:
• When the camera is initialized, the settings including the network settings will be initialized.
Note that the preset position settings and the CRT key (SSL encryption key) used for the
HTTPS protocol will not be initialized.
Step 1
Open the water-resistant cap by following steps
1-3 of the "Insert an SD memory card" section
(☞ page 25).
Step 2
Move the INITIAL SET switch to the right (ON).
• The factory default is OFF.
Step 3
Move the INITIAL SET switch to the right, and
then turn on the power of the camera. Turn on
the power of the camera and turn off (move it to
the left) the INITIAL SET switch about 15 seconds
later. After about 2 minutes the camera will start
up and the setting data including network setting
data will be initialized. If it is not initialized, please
try again.
(If it is initialized properly, the live indicator will
repeat twice the blinking action like blinking
orange → lighting orange → blinking orange
after the action of lighting orange → turning off.)
IMPORTANT:
• When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
• Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
① INITIAL SET switch
(OFF⇔ON)
SD memory card slot
②Power indicator
③Live indicator
Step 4
Turn off the power of the camera.
IMPORTANT:
• If the INITIAL SET switch is positioned to
the "ON" side, the camera cannot enter
the normal operation mode. Be sure to
return the INITIAL SET switch to the
"OFF" position.
Step 5
Return the water-resistant cap and the main
sunshield rear cover to the original state by fol-
lowing step 5 of the "Insert an SD memory
card" section (☞ page 26).
Step 6
Turn on the power of the camera.
23

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wv-x6511n

Table of Contents