Panasonic WV-X6531N Important Information Manual page 18

■ Cables
②Power cable
①RJ45 (female) Network cable
①RJ45 (female) Network cable
Connect an Ethernet cable (category 5e or better, straight) to the network connector.
IMPORTANT:
• Use all 4 pairs (8 pins) of the Ethernet cable.
• Make sure that the PoE+ device in use is compliant with IEEE802.3at standard.
• When connecting both the 24 V AC power supply and the PoE+ device for power supply,
24 V AC will be used for power supply.
• When the Ethernet cable is disconnected once, reconnect the cable after around 2 seconds.
When the cable is quickly reconnected, the power may not be supplied from the PoE+ device.
Brown
To the power supply (24 V AC, 50 Hz/60 Hz)
Blue
GND
Black
RJ45 waterproof
connector (accessory)
⑤Alarm input/output cable
⑤8P alarm cable (accessory)
③Audio input cable (white)
To a plug-in power type microphone
④Audio output cable (black)
To an external powered speaker
* This illustration represents WV-X6531N
18
Ethernet cable
(category 5e or better, straight)
To a PoE+ hub,
PC, etc.
To a sensor