Panasonic WV-X6531N Important Information Manual page 11

About the automatic status detection
function
When this product malfunctions due to exoge-
nous noise, etc. for 30 seconds or more, the
product will automatically reset and will return to
normal state. When the product is reset, initializa-
tion will be carried out as when the power of the
product is turned on. When the product repeat-
edly resets, exogenous noise level around the
product may be high and that may cause mal-
function. Contact your dealer for instructions.
Periodically images on the screen appear
to be distorted
When the camera is installed in a location where
it is subject to small vibrations (for example,
when it is installed near devices that vibrate),
images may appear distorted and stretched
lengthways. This phenomenon is a characteris-
tic of image pickup devices that use MOS sen-
sors and is caused by the relationship between
the periodic movements of the camera and the
timing that the image sensor reads images. This
is not a problem with the camera. To reduce the
possibility of this phenomenon occurring, install
the camera in a secure location.
About the dehumidifying device
• This product has dehumidifying device to
keep the inside at low moisture level, pre-
venting condensation and quickly dissipat-
ing dew if produced.
• Dew may be produced depending on the
conditions of temperature, humidity, winds,
and rain, and it may take time to dehumidify.
* The main sunshield rear cover and
the indication label are omitted.
What to do if "WARMING UP-PLEASE
WAIT" appears on the display.
This message indicates that the temperature
inside the camera has become extremely low.
The camera will be automatically restarted
when the inside the camera is warmed up by
the built-in heater. Please wait for a while.
We shall not be liable for content
compensation, losses of recorded or
edited content and any direct or indirect
consequent damages caused by failure to
record or edit due to faults with this unit or
the SD memory card. In addition, the same
provisions apply after unit is reparied.
About the MOS image sensor
• When continuously shooting a bright light
• When shooting fast-moving subjects or
Cleaning this product body
Be sure to turn off the power before cleaning.
Failure to observe this may cause injury. Do not
use benzine, thinner, alcohol, or any other
types of solvents or detergents. Otherwise, it
may cause discoloration. When using a chemi-
cal cloth for cleaning, read the caution provid-
ed with the chemical cloth product.
* Do not loozen or remove screws unless instruct-
ed to do so in the product documentation.
* The camera position may be moved inadver-
Dehumidifying
tently while cleaning the camera body. Restart
device
the product or refresh the camera position
(position refresh) to correct the camera posi-
tion. Refer to the Operating Instructions on
the provided CD-ROM for further information.
11
source such as a spotlight, the color filter
of the MOS image sensor may become
deteriorated and this may cause discolor-
ation. Even when changing the fixed
shooting direction after continuously
shooting a spotlight for a certain period,
the discoloration may remain.
performing panning/tilting operations,
objects crossing the shooting area may
look to be bending askew.