Table of Contents
Advertisement
Onkyo Dock
There's no sound.
• Make sure that the Onkyo Dock is connected to the
integrated amplifier properly.
• Make sure that no video content is being played.
• Reset the iPod.
Other
• When the Auto Standby (ASb) function is activated, the
power of the Onkyo Dock connected via
automatically turned off (
Can't control properly by using the remote
controller.
• Make sure that the
cable is connected to the integrated
amplifier correctly.
External Components
No sound is heard from a connected
component.
• Make sure the correct input source is selected
(
).
page 23
• Make sure the analog audio cable is connected correctly
(
).
page 14
When the
interlock does not function
properly
• Check that each device is connected correctly and that the
RI MODE is set correctly (
• The connecting method may vary depending on the device
that will be connected. Please refer to the
section in the owner's manual of the connected device.
The sound from turntable is distorted.
• If your turntable has a built-in phono preamp, connect to
other analog inputs such as LINE IN.
• If your turntable does not have a built-in phono preamp,
connect a turntable to PHONO (
• Make sure that the ground wire is connected. Otherwise, it
may produce an audible hum and noise.
• Confirm that the MM/MC input setting is correct for the
type of cartridge in the turntable.
is
).
page 25
).
page 26
connection
).
page 18
Remote Controller
The remote controller doesn't work
properly.
• Make sure the batteries have been installed with the correct
polarity (+/–) (
).
page 7
• Replace both batteries with new ones. (Do not mix different
types of batteries or new and old batteries.)
• The remote controller is too far away from the integrated
amplifier, or there's an obstacle between them (
• The integrated amplifier's remote control sensor is being
subjected to bright light (inverter-type fluorescent light or
sunlight).
• The integrated amplifier is located behind the glass doors
of an audio rack or cabinet.
Onkyo is not responsible for damages (such as CD
rental fees) due to unsuccessful recordings caused by
the unit's malfunction. Before you record important
data, make sure that the material will be recorded
correctly.
The integrated amplifier contains a microcomputer
for signal processing and control functions. In very
rare situations, severe interference, noise from an
external source, or static electricity may cause it to
lockup. In the unlikely event that this should happen,
unplug the power cord, wait at least 5 seconds, and
then plug it again.
Before disconnecting the power cord from the wall
outlet, set the integrated amplifier to Standby.
If during idling the cover is too hot to touch, then
ventilation needs to be improved.
).
page 7
En
29
Hide quick links:
Advertisement
Table of Contents
